bonnet safety catch

Post any Tech Tips or any matters and questions relating to upkeep
Post Reply
misterljk
Posts: 2
Joined: Mon Feb 29, 2016 3:57 pm

bonnet safety catch

Post by misterljk » Fri Sep 07, 2018 1:43 pm

The bonnet safety catch is not releasing and cannot gain access to release it.
Laurie Kipling

BillRo
Posts: 10
Joined: Wed Apr 01, 2015 7:26 pm

Re: bonnet safety catch

Post by BillRo » Fri Sep 07, 2018 4:41 pm

You will have to reach into the grille and loosen the hinge bolts. Once you get it open, loosen and adjust the pin and latch, so that the pin is centered properly (use plastercine?) and re-tighten. Good luck!

garyf
Posts: 238
Joined: Tue Jan 16, 2018 2:14 pm

Re: bonnet safety catch

Post by garyf » Fri Sep 07, 2018 4:44 pm

Try pushing down on the bonnet in the vicinity of the catch whilst someone else pulls the bonnet release?

It may need some adjustment.

Brad1380
Posts: 547
Joined: Wed Apr 27, 2011 1:38 pm

Re: bonnet safety catch

Post by Brad1380 » Sun Sep 09, 2018 1:10 pm

Once you do get it open add a lanyard wire to the mechanism as a safety measure.
1966 Sunbeam Tiger Mk1

misterljk
Posts: 2
Joined: Mon Feb 29, 2016 3:57 pm

Re: bonnet safety catch

Post by misterljk » Fri Sep 14, 2018 11:20 am

Thanks for suggestions: Pressing down to ease pressure on catch was not successful. I am attempting to undo bolts on front hinges. Making slow progress so far, I've released 2 from each side but access very difficult as the electric fan and air horn are restricting spanner or socket access.

Post Reply