Hi guys
As my car has had new front and rear wings fitted could someone please tell me how many clips fasten the stainless strips to the wings and how far from the edges the holes start?
Drilling wings for Tiger strips?
-
- Posts: 650
- Joined: Sun Dec 30, 2007 10:57 am
Re: Drilling wings for Tiger strips?
they not tiger wings then?Ash wrote:Hi guys
As my car has had new front and rear wings fitted could someone please tell me how many clips fasten the stainless strips to the wings and how far from the edges the holes start?
Re: Drilling wings for Tiger strips?
They are now!garyv8tiger wrote:they not tiger wings then?Ash wrote:Hi guys
As my car has had new front and rear wings fitted could someone please tell me how many clips fasten the stainless strips to the wings and how far from the edges the holes start?
Think I have sorted it?
My original Tiger door has a hole 3" from the front edge then a hole every 6.5"
Rear wing I measured 1.5" in from front edge then marked for a hole. Then mark every 6.5" and the last hole is approximately 1.5" from the edge of the sunbeam sheild.
Just the front wings to sort now
My original Tiger door has a hole 3" from the front edge then a hole every 6.5"
Rear wing I measured 1.5" in from front edge then marked for a hole. Then mark every 6.5" and the last hole is approximately 1.5" from the edge of the sunbeam sheild.
Just the front wings to sort now
Thank you, am also interested in the front wings, both of mine replaced.Ash wrote:Think I have sorted it?
My original Tiger door has a hole 3" from the front edge then a hole every 6.5"
Rear wing I measured 1.5" in from front edge then marked for a hole. Then mark every 6.5" and the last hole is approximately 1.5" from the edge of the sunbeam sheild.
Just the front wings to sort now
Merry Christmas
Steven