C3AZ-7515-A Clutch fork

Post any Tech Tips or any matters and questions relating to upkeep
Post Reply
eagleman1022
Posts: 4
Joined: Thu Mar 01, 2012 5:02 am

C3AZ-7515-A Clutch fork

Post by eagleman1022 » Fri Mar 02, 2012 5:28 pm

I can't seem to find a clutch fork #C3AZ-7515-A as used on the 5 bolt Tiger bell housing. Does anyone know of a source or a good substitue?

eagleman1022
Posts: 4
Joined: Thu Mar 01, 2012 5:02 am

Clutch Fork C3AZ-7515-A

Post by eagleman1022 » Sun Feb 24, 2013 3:44 am

Still looking for the clutch fork or a suitable or modifiable replacement. Also, Can someone tell me how much clearance there is between the end of the stock fork and and body panels. That will tell me if I can install a longer fork since I can't find the 10" one.

Mal
Posts: 672
Joined: Sat Aug 02, 2008 5:39 am
Location: NZ

Post by Mal » Sun Feb 24, 2013 3:54 am

From the closest point, approx 35mm.

Cheers
Image

V8 burble
Posts: 278
Joined: Thu Sep 03, 2009 10:13 am

Post by V8 burble » Fri Mar 29, 2013 4:17 pm

There is a brand new, old stock one here:

http://www.ebay.com.au/itm/NOS-1963-196 ... 5aef871a56

bigbob
Posts: 379
Joined: Wed Aug 19, 2009 11:31 am

Post by bigbob » Fri Mar 29, 2013 5:08 pm

I'm sure I have an old one knocking about somewhere in the garage. I switched to the later type which pivots off a ball joint, too suit my Tremec.

Post Reply