sunbeamtiger.co.uk

I have a set of the cross wire supports needed for the headlining of the hard top. Offers please.
Chris 07518 534111

I have a pair of rear springs for Tiger. Look in fair condition. Reasonable offers please.
Chris 07518 534111

I have two of these wheels for sale. Will fit Tiger best on rear as they are offset slightly too far out for fronts. Tyres are older 185/60 A520 Yoko's, but good tread. ALSO: 1 x 5.5J x 14 deep dish wheel with unworn track day Yoko A048, 185/60 tyre - offset suitable for fitting to rear (I have two ...

I have a Bell housing which I believe matches the later, 5-bolt engines (302 etc) to fit the Tiger original gearbox (Toploader). Now having a clear out so want to sell asap. I believe I paid around £100 a while ago so looking to get money back o.n.o. I can post pic if required. Number on casting is ...

The magazine has a Brooklands event on Sunday, but nothing on that day on the website events page.

Any info on this meeting please?

Does the brake pedal have the same travel on the new calipers?

Jack up the car at the rear allowing the wheels to fully drop. Then measure the lowest axle position. I would use that as the highest point where the exhaust should run under the axle.

The rectangular headers remind me of the waveguides I used to work on in my days as an engineer. We used to wind them into coils for radar applications.

Hi Tony It was good to meet you too at the show. Yes those are the clips. Since I first posted, a fellow Tiger owner was kind enough to let me have some clips, which, despite my earlier comments, I have used, and so far so good as they are holding. I now need to get some inner strip clips from somew...

I have just removed the drivers door to repair the door skin, and whilst doing that, refurb the window channels, and all the rest of it. The door seal retainer at the bottom was rusted out so I will fit a new one using some spare retainer that I had. Getting the curves matched on the door bottom was...

Now sold.

Thanks. I bought the bush to get the outer dimensions to make a new bush for when I fit a T5 transmission (which has a smaller shaft).

All I need to do now is sort the speedometer drive.

For relining companies quite a few come up on Google search inc http://www.pastparts.co.uk/reman.htm

I have a new crank bearing spigot bush which measures 35mm OD and 17mm ID, 12.8 depth. Bought from Real Steel. (1.377 x 0.67 x 0.503 inches)

Can anyone please confirm this is the right size for a Tiger?

Thanks.

In cases where I cant buy a replacement on its own I often wind my own springs from spring wire or 'piano' wire. This one could be tricky though as the diameter is not constant.